Xerox 5550DT User Guide (English) - Page 38

Configuring the Network Address Manually Setting the Printer's IP Address Note: Verify that your computer has a properly configured IP address for your network. Contact your network administrator for more information. If you are on a network without a DHCP server, or in an environment where the network administrator assigns printer IP addresses, you can use this method to manually set the IP address. Manually setting the IP address overrides DHCP and AutoIP. Alternatively, if you are in a small office with a single PC and use a dialup modem connection, you can manually set the IP address. Information Required for Manual IP Addressing Information Internet Protocol (IP) address of the printer Network Mask Default Router/Gateway address Comments Format is xxx.xxx.xxx.xxx, where xxx represents a decimal number from 0-255. If you are unsure, leave this blank; the printer chooses an appropriate mask. Router address is required to communicate with the host device from anywhere other than the local network segment. Using the Control Panel To manually set the IP address: 1. On the control panel, select Printer Setup, and then press the OK button. 2. Select Connection Setup, and then press the OK button. 3. Select Network Setup, and then press the OK button. 4. Select TCP/IPv4 Setup, and then press the OK button. 5. Select DHCP/BOOTP, and then press the OK button to select Off. 6. Select IPv4 Address, and then press the OK button. 7. Enter the printer's IP address, and then press the OK button. Phaser® 5550 Printer 3-8