ZyXEL VMG4927-B50A User Guide - Page 27
RESET Button, Wall Mounting
View all ZyXEL VMG4927-B50A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Chapter 1 VMG Introduction Rear Panel Ports (continued) LABEL DESCRIPTION PHONE1 ~ PHONE2 Connect analog phones to the phone ports to make phone calls. Reset Press the button to return the VMG to the factory defaults. Power Connect the power cable to start the VMG. 1.4.5 RESET Button If you forget your password or cannot access the Web Configurator, you will need to use the RESET button at the back of the device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to the factory default (see the device label). 1 Make sure the POWER LED is on (not blinking). 2 To set the device back to the factory default settings, press the RESET button for more than five seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the device restarts. 1.4.6 Wall Mounting You may need screw anchors if mounting on a concrete or brick wall. Table 4 Wall Mounting Information Distance between holes Screws Screw anchors (optional) 88 mm Two Two The following figure introduces the specifications of the screws and screws anchors for wall mounting. Figure 12 Screws & Screw Anchors Specifications VMG4927-B50A / VMG9827-B50A User's Guide 27