ZyXEL VMG4927-B50A User Guide - Page 79
ADSL over ATM, LABEL, DESCRIPTION, Enable, Disable
View all ZyXEL VMG4927-B50A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Chapter 6 Broadband Figure 29 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM - Bridge Mode) The following table describes the fields in this screen. Table 12 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM - Bridge or Ethernet Mode) LABEL DESCRIPTION General Active Select Enable or Disable to activate or deactivate the interface. Name Enter a service name of the connection. Type Select ADSL/VDSL over PTM as the interface that you want to configure. The VMG uses the VDSL technology for data transmission over the DSL port. Mode Select Bridge when your ISP provides you more than one IP address and you want the connected computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the selected LAN port(s). VLAN This section is available only when you select ADSL/VDSL over PTM in the Type field. Active Select Enable to enable VLAN on this WAN interface. 802.1p IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to define class of service. Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater the number, the higher the priority level. 802.1q Type the VLAN ID number (from 0 to 4094) for traffic through this connection. OK Click OK to save your changes. Cancel Click Cancel to exit this screen without saving. If you select ADSL over ATM as the interface type, the following screen appears. VMG4927-B50A / VMG9827-B50A User's Guide 79