2008 Acura TSX Owner's Manual - Page 238

Main Menu Table Of Contents Service Station Procedure To Close the Hood: Lift it up slightly to remove the support rod from the hole. Put the support rod back into its holding clip. Lower the hood to about a foot (30 cm) above the fender, then let it drop. Make sure it is securely latched. Before Driving LATCH GRIP SUPPORT ROD CLIP 2. Put your fingers under the front edge of the hood near the center. Slide your hand to the left until you feel the hood latch handle. Push this handle up to release it. Lift up the hood. If the hood latch handle moves stiffly, or if you can open the hood without lifting the handle, the mechanism should be cleaned and lubricated. 3. Pull the support rod out of its clip by holding the grip, and insert the end into the designated hole in the hood. 2008 TSX 235