2008 Acura TSX Owner's Manual - Page 297

Main Menu Table Of Contents Changing the Engine Oil and Filter OIL FILTER 8. Put a new washer on the drain bolt, then reinstall the drain bolt. Tighten it to: 33 lbf·ft (45 N·m , 4.6 kgf·m) 9. Refill the engine with the recommended oil. Engine oil change capacity (including filter): 4.4 US qt (4.2 ) 12.Turn off the engine, let it sit for several minutes, then check the oil level on the dipstick. If necessary, add more oil. 13.Install the maintenance cover and tighten the bolt securely. 6. Check the oil filter to make sure its gasket did not stick to the filter base. A stuck gasket could cause an oil leak. 7. Install a new oil filter according to the instructions that come with it. Make sure to clean off any dirt and dust on the connecting surface of a new oil filter. 10.Replace the engine oil fill cap. Start the engine. The oil pressure indicator should go out within 5 seconds. If it does not, turn off the engine, and check your work. 11.Let the engine run for several minutes, then check the drain bolt and oil filter for leaks. Improper disposal of engine oil can be harmf ul to the environment. If you change your own oil, please dispose of the used oil properly. Put it in a sealed container and take it to a recycling center. Do not discard it in a trash bin or dump it on the ground. 294 2008 TSX