2008 Acura TSX Owner's Manual - Page 316
2008 Acura TSX Manual
Page 316 highlights
Main Menu Table Of Contents Wiper Blades 5. Install the new blade onto the blade assembly: Pull back either end of the blade assembly. Place the side of the blade not labeled ''LOCK'' on the end of the blade assembly, and slide the blade onto the assembly until it is fully installed. 6. Slide the wiper blade assembly onto the wiper arm. Make sure it locks in place. Maintenance BLADE WIPER BLADE REINFORCEMENT 3. Remove the blade from the blade assembly: Find the side of the blade labeled ''LOCK.'' This is the side you pull out. Pull back the end of the blade assembly on the ''LOCK'' side of the blade. Then grab the end of the blade, and slide it out. 4. Examine the new wiper blades. If they have no plastic or metal reinforcement along the back edge, remove the metal reinforcement strips from the old wiper blade, and install them in the slots along the edge of the new blade. 7. Make sure the blade is completely installed and that its edge is not bunched up. 8. Lower the wiper arm down against the windshield, the passenger's side first, then the driver's side. 2008 TSX 313