2008 Acura TSX Owner's Manual - Page 307

Main Menu Table Of Contents Lights 6. Insert the socket back into the headlight assembly. Make sure the bulb is installed correctly by looking through the headlight lens. Pivot the hold-down wire back in place, and clip the end into the slot. 7. Install the rubber weather seal over the back of the headlight assembly. Make sure it is right side up; it is marked with an arrow. 8. Push the electrical connector onto the socket. Make sure it is connected securely. 9. Turn on the headlights to test the new bulb. 10.On the driver's side, reinstall the air intake cover. Reinstall the three fasteners and secure them by pushing on the heads until they lock. SOCKET Replacing the Turn Signal Light Bulb BULB 3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms. 4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place. 5. Turn on the lights to test the new bulb. 1. Open the hood. 2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise. 304 2008 TSX