1994 Chevrolet Corvette Owner's Manual - Page 157

Problems on the Road 4. Fill with the proper mix. Add coolant 9. Shut the engine off and replace the pressure cap. Be sure the arrows on until you see a steady stream of the pressure cap line up like this. coolant coming from the bleed valves. 5. Close the bleed valves. 6. Continue to fill the coolant high fill reservoir up to the base of the filler neck. 7. Rinse or wipe the spilledcoolant from the engine and compartment. 8. Start the engine and allow it to run in idle for approximately four minutes. By this time, the coolant level inside the coolant high fill reservoir will be lower. Add more of the proper mix through the filler neck until the level reaches the base of the filler neck. 10. Then fill the coolant recovery tank to the proper level. For a complete drain, flush and refill, see your Chevrolet dealer a Chevrolet or Corvette Service Manual. purchase a To service manual, see "Service Publications'' in the Index. ...156