1994 Chevrolet Corvette Owner's Manual - Page 66

. 1 " . I\ W To Resume a SetSpeed 2. Get up to the speed you want. 3. Push in the set button at the end of the Suppose you set your Cruise Control at a desired speed and then you apply the lever and release it. brake or clutch pedal. This, of course, 4. Take your foot off the accelerator shuts off the Cruise Control. But you pedal. don't need to reset it. Once you're going about 25 mph (40 km/h) or more, you c a ~ move the Cruise Control switch to "WA" (Resume/Accelerate) for about ha1 a second. You'll go right back up to your chosen speed and stay there. To Increase Speed While Using Cruise Control There are two ways to go to a higher speed. Here's the first: 1. Use the accelerator pedal to get to the higher speed. 2. Push the button at the end of the lever, then release the button and the accelerator pedal. You'll now cruise at the higher speed. Here's the second way to go to a higher speed: 1. Move the Cruise switch to W A . " Hold it there until you get up to the speed you want, and thenrelease the switch. To increase your speed in very small amounts, move the switch to "WA" for less than halfa second and then release it. Each time youdo this, your vehicle will go about one mph (1.6 km/h) faster. To Reduce Speed While Using Cruise Control There are two waysto reduce your speed while using cruise control: 1. Push in the button at the end of the lever until you reach the lower speed you want, then release it. 2. To slow down in very small amounts, push the button for less than half a second. Each time youdo this, you'll go one mph (1.6 km/h) slower. 65. .