1994 Chevrolet Corvette Owner's Manual - Page 73

Features and Controls 6. Gently lift up on the roof panel to be sure it is locked in place. Installing theRoof Panel 3. Lower the roof panel onto the vehicle, rear edge first, and place therear guide pins into the holes in the roof opening. 4. Lower the front of the roof panel, and align the front guide pins. 5. Tighten the rear bolts part way. NOTICE: If you tighten bolts that are improperly started, the threads can become stripped. Be sure all bolts are properly started before you tighten them. Storage and Compartments Center Console To use the storage area, push the button on the front endof the console and lift. You can use the door key to lock and unlock the console. Don't leave the key in the lock, or it could be damaged when the driver sits down. 6. Use the ratchet to start the front bolts. 1. Park on a level surface, set the parking If the bolts are hard to start, tighten brake firmly andshift an automatic the rear bolts some more. Holding transmission into "P" (Park). Shift a down the panel on the outside will manual transmission into " R ' also help. (Reverse).. Lower bothwindows, turn the ignition keyto "LOCK" and move 7. Fully tighten the rear bolts, then the front bolts. both sunshades tothe side. If you hear a popping noise when you 2. If the roof panel isstored in the rear drive, the bolts may not be tight enough. area, remove it by reversing the steps under "Storing the Roof Panel" above. Be sure to tighten'them securely. ...72