1998 Chevrolet Venture Owner's Manual - Page 158
1998 Chevrolet Venture Manual
Page 158 highlights
Entering Programming Mode To program features, your vehicle must be in the programming mode. Follow these steps: Delayed Illumination and Exit Lighting With Delayed Illumination, the interior lamps will stay on for about 25 seconds after allthe doors and the liftgate are closed. With Exiting Lighting, the interior lamps will come on and stay on for about 25 seconds whenever you remove the key from the ignition. 1. The Content Theft-Deterrent system (if equipped) must be disarmed. See "Content Theft-Deterrent System" in this section. 2. Remove the BCM PRGRM fuse from the instrument panel fuse block, located to the right of the glove box. (See "Fuses and Circuit Breakers" in the Index.) To customize these features to your preference, see "ProgrammableModes" following. Programmable Modes Your vehicle can be programmed to one of the following modes. 3. Close the driver's door. 4. Turn the ignition switch towards you to ACCESSORY. 5 . Count the number of chimes you hear. You will hear two to four chimes depending on the features your vehicle isequipped with. Refer to the chart shown previously. You can now programyour choices. To exit the programming mode,follow the steps listed under "ExitingProgramming Mode" later in this section. Mode 1: Both Features Off (The interior lamps will turn on oroff at the same instant that a door is opened or closed.) Mode 2 : Delayed Illumination Only(The interior lamps will stay onfor about 25 seconds after all thedoors and liftgate are closed,or until you lock the doors.) Mode 3: Exit Lighting Only (The interior lamps will come on whenever you remove the key from the ignition and stay on for about 25 seconds, or until you lock the doors.) 2-41