1998 Chevrolet Venture Owner's Manual - Page 331
1998 Chevrolet Venture Manual
Page 331 highlights
Unless you have the plastic "bolt-on" wheel covers, be sure to also store the center cap. When you replace the compact spare with a full-size tire, replace the bolt-on wheel covers and the center cap. Tighten them "hand tight" over the wheel nuts, using the folding wrench. .BAG & TOOLS Compact Spare Tire Although the compact spare tire was fully inflated when your vehicle was new, it can lose air after a time. Check the inflation pressure regularly. It should be 60 psi (420 P a ) . NOTE: INSTALL, BOlTOM OF BAG I After installing the compact spare on your vehicle, you should stop as soon as possible and make sure your spare tireis correctly inflated. The compact spare is made to perform well at speedsup to 65 mph (105 TOOL STORAGE km/h) for distances up to3,000 miles (5 000 km), so you can finish your trip and have your full-size tire repaired Replace alljacking tools as they were stored in the jack or replaced where you want. Of course, it's best to storage compartment and replace the compartment replace your spare with a full-size tire as soon as you cover. To replace the cover, line up the tabs on the right can. Your spare will last longer and be in good shape in of the cover with the slots in the cover opening. Push the case you need it again. cover in place and push down the tab so that it rests in the groove. This secures the cover in place. 5-34