1998 Chevrolet Venture Owner's Manual - Page 372

8. To align the parking/turn signal lamp assembly with the headlamp assembly, lift up the parking/turn signal lamp assembly until the upper edge is contacting the fender. 9. Fasten the parkinghrn signal lamp assembly to the headlamp assembly with the thumb screw removed in Step 1. Taillamps 1. Open the liftgate. 2. Remove the two screws from the taillamp housing on the inboard side. 7. To replace the lamp assembly, line up and insert the tabs on the back of the assembly with the slots in the fender. Engage the lower clip on the frontof the lamp assembly, keeping the upper tab on the parkinghrn signal lamp assembly inboard of the headlamp bracket tab. 3. Pull off the entire taillamp housing. The locator/retaining pins on the outboard side are part of the lamp assembly and will remain intact during removal. 6-37