2010 Chrysler 300 Owner Manual SRT8 - Page 147
2010 Chrysler 300 Manual
Page 147 highlights
146 UNDERSTANDING THE FEATURES OF YOUR VEHICLE If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective. NOTE: A "Turn Signal On" message will appear in the EVIC and a continuous chime will sound if the vehicle is driven more than 1 mile (1.6 km) with either turn signal on. Flash-To-Pass You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will cause the headlights to turn on at high beam and remain on until the multifunction lever is released. Overhead Console Map/Reading Lights These lights are mounted between the sun visors on the overhead console. Each light is turned on by pressing the lens. Press the lens a second time to turn off the light. These lights also turn on when a door is opened, or when Lane Change Assist the UNLOCK button on the Remote Keyless Entry (RKE) Tap the lever up or down once, without moving beyond transmitter is pressed, or when the dimmer control is the detent, and the turn signal (right or left) will flash turned fully upward, past the second detent. three times then automatically turn off. High/Low Beam Switch Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you to switch the headlights back to low beam.