2010 Chrysler 300 Owner Manual SRT8 - Page 355
2010 Chrysler 300 Manual
Page 355 highlights
354 WHAT TO DO IN EMERGENCIES 1. Turn the Mode Select Knob (5) to the Air Mode Deflation Button to reduce the tire pressure to the position. recommended inflation pressure before continuing. 2. Uncoil the Air Pump Hose (7) and connect it to the 2. Disconnect the TIREFIT kit from the valve stem and valve stem. then reinstall the cap on the valve stem. 3. Check the pressure in the tire by reading the Pressure 3. Place the TIREFIT kit in its proper storage area in the Gauge (3). vehicle. If tire pressure is less than 19 psi (1.3 Bar) , the tire is too 4. Have the tire inspected and repaired or replaced at the badly damaged. Do not attempt to drive the vehicle earliest opportunity at an authorized dealer or tire serfurther. Call for assistance. vice center. 5. Replace the Sealant Bottle (1) and Sealant Hose (6) assembly at your authorized dealer as soon as possible. 1. Press the Power Button (4) to on and inflate the tire to Refer to "(F) Sealant Bottle and Hose Replacement." the pressure indicated on the tire and loading information label on the driver-side door opening. NOTE: When having the tire serviced advise the authorized dealer or service center that the tire has been sealed NOTE: If the air pump is equipped with a Deflation using the TIREFIT service kit. Button and the tire becomes over-inflated, press the If the tire pressure is 19 psi (1.3 bar) or higher: