2010 Chrysler 300 Owner Manual SRT8 - Page 53
2010 Chrysler 300 Manual
Page 53 highlights
52 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 3. Within 60 seconds of turning the ignition switch to the BeltAlert Programming The BeltAlert can be enabled or disabled by your RUN position, unbuckle and then re-buckle the driver's authorized dealer or by performing the following steps: seat belt at least three times within 10 seconds, ending with the seat belt buckled. NOTE: Chrysler Group LLC does not recommend deactivating the BeltAlert. NOTE: Watch for the Seat Belt Reminder Light to turn on while unbuckling the seat belt and turn off while 1. With all doors closed, and the ignition switch in any re-buckling the seat belt. It may be necessary to retract position except RUN or START, buckle the driver's seat the seat belt. belt. 4. Turn the ignition switch to the OFF position. A single 2. Turn the ignition switch to the RUN position, but do chime will sound to signify that you have successfully not start the engine. Wait for the Seat Belt Reminder Light completed the programming. to turn off and then proceed to the next step. BeltAlert can be reactivated by repeating this procedure. NOTE: You must perform the following steps within 60 seconds of turning the ignition switch to the RUN NOTE: Although BeltAlert has been deactivated, the position. Seat Belt Reminder Light will continue to illuminate as long as the driver's seat belt is unbuckled.