2010 Chrysler 300 Owner Manual SRT8 - Page 356
2010 Chrysler 300 Manual
Page 356 highlights
WHAT TO DO IN EMERGENCIES 355 (F) Sealant Bottle and Hose Replacement: 1. Uncoil the Sealant Hose (6). housing. Then, press the bottle into the housing. An audible click will be heard, indicating the bottle is locked in place. 2. Locate the rectangular Sealant Bottle release button in 6. Verify the yellow cap is installed on the fitting at the the recessed area where you place your fingers to unlatch end of the Sealant Hose (6) and return the hose to its the hoses (6) (7) from their storage area. storage area (located on the bottom of the air pump). 3. Use the yellow cap on end of the Sealant Hose (6) to 7. Return the TIREFIT kit to its storage location in the depress the Sealant Bottle release button. The Sealant vehicle. Bottle (1) will pop up. Remove the bottle and dispose of it accordingly. JUMP-STARTING PROCEDURES 4. Clean any remaining sealant from the TIREFIT hous- If your vehicle has a discharged battery it can be jumpstarted using a set of jumper cables and a battery in ing. another vehicle or by using a portable battery booster 5. Position the new Sealant Bottle (1) to the housing so pack. Jump-starting can be dangerous if done improperly that the Sealant Hose (6) aligns with the hose slot in the so please follow the procedures in this section carefully. front of the housing and the alignment keys on the bottom of the bottle align with the alignment slots in the NOTE: When using a portable battery booster pack follow the manufacturer's operating instructions and precautions. 6