2010 Chrysler 300 Owner Manual SRT8 - Page 167
2010 Chrysler 300 Manual
Page 167 highlights
166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Programming HomeLinkா Before You Begin If you have not trained any of the HomeLink buttons, erase all channels before you begin training. For optimal training, point the battery end of the handheld transmitter away from the HomeLink. To do this, press and hold the two outside buttons for up to 20 seconds. The EVIC will display "CLEARING 3. Simultaneously, press and hold both the chosen CHANNELS." Release the buttons when the EVIC mes- HomeLink button and the handheld transmitter button until the EVIC display changes from "CHANNEL # sage states "CHANNELS CLEARED." TRAINING" to "CHANNEL # TRAINED." It is recommended that a new battery be placed in the handheld transmitter of the device that is being copied to Then release both the HomeLink and handheld transHomeLink for more efficient training and accurate mitter buttons. transmission of the radio-frequency signal. If the EVIC display states "DID NOT TRAIN" repeat Your vehicle should be parked outside of the garage Step 3. If the signal is too weak, replace the battery in the while training. handheld transmitter. 1. Place the ignition in the RUN position. It may take up to 30 seconds or longer in rare cases. The garage door may open and close while you train. 2. Place the handheld transmitter 1 to 3 in (3 to 8 cm) from the HomeLink buttons while keeping the EVIC display in view.