2010 Chrysler 300 Owner Manual SRT8 - Page 352
2010 Chrysler 300 Manual
Page 352 highlights
WHAT TO DO IN EMERGENCIES 351 3. Uncoil the Sealant Hose (6) and then remove the NOTE: Manual transmission vehicles must have the parking brake engaged and the shifter in NEUTRAL. yellow cap from the fitting at the end of the hose. 4. Place the TIREFIT kit flat on the ground next to the • After pressing the Power Button (4), the sealant (white fluid) will flow from the Sealant Bottle (1) through the deflated tire. Sealant Hose (6) and into the tire. 5. Remove the cap from the valve stem and then screw the fitting at the end of the Sealant Hose (6) onto the NOTE: Sealant may leak out through the puncture in the tire. valve stem. 6. Uncoil the Power Plug (8) and then insert the plug into If the sealant (white fluid) does not flow within 0 - 10 seconds through the Sealant Hose (6): the vehicle's 12 Volt power outlet. NOTE: Do not remove foreign objects (e.g., screws or 1. Press the Power Button (4) to turn OFF the TIREFIT kit. Disconnect the Sealant Hose (6) from the valve stem. nails) from the tire. Make sure the valve stem is free of debris. Reconnect the (C) Injecting TIREFIT Sealant into the deflated Sealant Hose (6) to the valve stem. Check that the Mode tire: Select Knob (5) is in the sealant mode position and not air • Always start the engine before turning ON the TIRE- mode. Press the Power Button (4) to turn ON the TIREFIT FIT kit. kit. 6