2010 Chrysler 300 Owner Manual SRT8 - Page 170

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169 successfully accepted the frequency signal. The EVIC 1. Place the ignition in the RUN position. display will change from "CHANNEL # TRAINING" to 2. Press and hold the desired HomeLink௡ button for "CHANNEL # TRAINED." 20 seconds until the EVIC display states "CHANNEL # If you unplugged the device for training, plug it back in TRAINING." Do not release the button. at this time. 3. Without releasing the button, proceed with ProgramThen proceed with Step 4 under "Programming ming HomeLink௡ Step 2 and follow all remaining steps. HomeLink௡" earlier in this section. Security Using HomeLinkா It is advised to erase all channels before you sell or turn To operate, press and release the programmed in your vehicle. HomeLink௡ button. Activation will now occur for the To do this, press and hold the two outside buttons for trained device (i.e., garage door opener, gate operator, 20 seconds until the EVIC message states "CHANNELS security system, entry door lock, home/office lighting, CLEARED." Note that all channels will be erased. Indietc.,). The handheld transmitter of the device may also be vidual channels cannot be erased. used at any time. The HomeLink௡ Universal Transceiver is disabled when Reprogramming A Single HomeLinkா Button the Vehicle Security Alarm is active. To reprogram a channel that has been previously trained, follow these steps: 3