2010 Chrysler Sebring Owner Manual Convertible - Page 17
2010 Chrysler Sebring Manual
Page 17 highlights
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Replacement Keys Customer Key Programming You can program new keys to the system if you have two NOTE: Only keys that have been programmed to the valid Sentry Keys by performing the following procevehicle electronics can be used to start the vehicle. Once dure: a Sentry Key has been programmed to a vehicle, it cannot be programmed to any other vehicle. 1. Cut the additional Sentry Key Transponder blank(s) to match the ignition switch lock cylinder key code. At the time of purchase, the original owner is provided with a four-digit Personal Identification Number (PIN). 2. Insert the first valid key into the ignition switch. Turn This PIN is required for authorized dealer replacement of the ignition switch to the ON position for at least three keys. Duplication of keys may be performed at an seconds, but no longer than 15 seconds. Then, turn the authorized dealer or by using the Customer Key Pro- ignition switch to the LOCK position and remove the first gramming procedure. This procedure consists of pro- key. gramming a blank key to the vehicle electronics. A blank 3. Insert the second valid key into the ignition switch. key is one which has never been programmed. Turn the ignition switch to the ON position within NOTE: When having the Sentry Key Immobilizer 15 seconds. After 10 seconds, a chime will sound. In System serviced, bring all vehicle keys with you to an addition, the Vehicle Security Light will begin to flash. authorized dealer. Turn the ignition switch to the LOCK position and remove the second key.