2010 Chrysler Sebring Owner Manual Convertible - Page 269
2010 Chrysler Sebring Manual
Page 269 highlights
268 STARTING AND OPERATING The "Anti-Lock Brake Warning Light" monitors the Anti-Lock Brake System. The light will come on when the ignition switch is turned to the ON position and may stay on for as long as four seconds. (ABS) and Electronic Brake Force Distribution (EBD) Systems are not functioning. Immediate repair to the ABS system is required. See your authorized dealer. When the vehicle is driven over 7 mph (11 km/h), you may hear a slight clicking sound as well as some related motor noises. These noises are the system performing its self-check cycle to ensure that the ABS system is working properly. This self check occurs each time the vehicle is started and accelerated past 7 mph (11 km/h). If the "Anti-Lock Brake Warning Light" remains on or comes on while driving, it indicates that the anti-lock portion of the brake system is not functioning and that service is required. However, the conventional brake system will continue to operate normally if the "Brake ABS is activated during braking under certain road or Warning Light" is not on. stopping conditions. ABS-inducing conditions can inIf the "Anti-Lock Brake Warning Light" is on, the brake clude ice, snow, gravel, bumps, railroad tracks, loose system should be serviced as soon as possible to restore debris, or panic stops. the benefits of anti-lock brakes. If the "Anti-Lock Brake Warning Light" does not come on when the ignition You also may experience the following when the brake switch is turned to the ON position, have the bulb system goes into anti-lock: repaired as soon as possible. • The ABS motor running (it may continue to run for a If both the "Brake Warning Light" and the "Anti-Lock short time after the stop), Brake Warning Light" remain on, the Anti-Lock Brake