2010 Chrysler Sebring Owner Manual Convertible - Page 30

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29 the ignition switch must be cycled to the ON position DOOR LOCKS before you can repeat the start sequence for a third cycle. Manual Door Locks To Exit Remote Start Mode without Driving the To lock each door, push the door lock plunger on each Vehicle door trim panel downward. To unlock each door, pull the Press and release the REMOTE START button one time or door lock plunger on each door trim panel upward. allow the engine to run for the entire 15 minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press of the remote start button for two seconds after receiving a valid remote start request. To Exit Remote Start Mode and Drive the Vehicle Before the end of the 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). NOTE: The ignition switch must be in the ON position in order to drive the vehicle. Manual Lock Plunger 2