2010 Chrysler Sebring Owner Manual Convertible - Page 338
2010 Chrysler Sebring Manual
Page 338 highlights
WHAT TO DO IN EMERGENCIES 337 CAUTION! Do not attempt to raise the vehicle by jacking on locations other than those indicated in Step 3. 3. There is one front jacking location and one rear jacking location on each side of the vehicle. The front locations are outlined by two triangular cutouts, the rear ones by two rectangular cutouts. For vehicles equipped with plastic trim, the plastic has been cut away to expose the jacking locations in the body. head is properly engaged with the lift area closest to the wheel to be changed. Do not raise the vehicle until you are sure the jack is securely engaged. WARNING! Raising the vehicle higher than necessary can make the vehicle less stable. It could slip off the jack and hurt someone near it. Raise the vehicle only enough to remove the tire. 5. Raise the vehicle by turning the jack screw to the right, Do not raise the vehicle until you are sure the jack is using the swivel wrench. Raise the vehicle only until the tire just clears the surface and enough clearance is securely engaged. obtained to install the spare tire. Minimum tire lift 4. Turn the jack screw to the left until the jack can be provides maximum stability. placed under the jacking location. Once the jack is positioned, turn the jack screw to the right until the jack 6. Remove the wheel nuts, and pull the wheel and wheel covers (if equipped) off the hub. Install the spare wheel and wheel nuts with the cone shaped end of the nuts 6