2010 Chrysler Sebring Owner Manual Convertible - Page 331
2010 Chrysler Sebring Manual
Page 331 highlights
330 WHAT TO DO IN EMERGENCIES HAZARD WARNING FLASHER IF YOUR ENGINE OVERHEATS The Hazard Warning flasher switch is located on the In any of the following situations, you can reduce the instrument panel, below the radio. potential for overheating by taking the appropriate action. Press the switch to turn on the Hazard Warning • On the highways - Slow down. flasher. When the switch is activated, all directional • In city traffic - While stopped, put transaxle in turn signals will flash on and off to warn oncoming NEUTRAL, but do not increase engine idle speed. traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flasher. CAUTION! This is an emergency warning system and should not be used when the vehicle is in motion. Use it when your vehicle is disabled and is creating a safety hazard for other motorists. If it is necessary to leave the vehicle to go for service, the Hazard Warning flasher will continue to operate with the ignition key removed and the vehicle locked. NOTE: With extended use, the Hazard Warning flasher may wear down your battery. Driving with a hot cooling system could damage your vehicle. If the pointer rises to the H (red) mark, the instrument cluster will sound a chime. When safe, pull over and stop the vehicle with the engine at idle. Turn off the air conditioning and wait until the pointer drops back into the normal range. If the pointer remains on the H (red) mark for more than a minute, turn the engine off immediately and call for service.