2010 Mazda MAZDA3 Owner's Manual - Page 118
2010 Mazda MAZDA3 Manual
Page 118 highlights
Knowing Your Mazda Doors and Locks NOTE If the battery was disconnected during vehicle maintenance, or for other reasons such as a switch continues to be operated after the window is fully open/close, the window will not fully open and close automatically. Carry out the following procedure to resume operation: 1. Turn the ignition switch to the ON position. 2. Press the switch and fully open the window. 3. Pull up the switch to fully close the window and continue holding the switch for about 2 seconds after the window fully closes. Engine-off power window operation The power window can be operated for about 45 seconds after the ignition switch is turned from the ON position to the ACC or LOCK position with all doors closed. If any door is opened, the power window will be inoperable. NOTE For engine-off operation of the power window, the switch must be held up firmly throughout window closure because the auto-closing function will be inoperable. Jam-safe window If a person's hands, head or an object blocks the window during the autoclosing operation, the window will stop and open halfway. qOperating the Passenger Power Windows The power windows may be operated when the power window lock switch on the driver's door is in the unlocked position. The passenger windows may be opened or closed by the power window master control switches on the driver's door. Owner master control switch Driver's window Left rear window Front passenger's window Right rear window WARNING Make sure nothing blocks the window just before it reaches the fully closed position or while holding up the power window switch: Blocking the power window just before it reaches the fully closed position or while holding up the power window switch is dangerous. In this case, the jam-safe function cannot prevent the window from closing all the way. If fingers are caught, serious injuries could occur. NOTE Depending on driving conditions, a closing power window could stop and start opening when the window feels a shock that is similar to something blocking it. In the event the jam-safe function activates and the power window cannot be closed automatically, pull and hold the switch and the window will close. 3-42