2010 Mazda MAZDA3 Owner's Manual - Page 285
2010 Mazda MAZDA3 Manual
Page 285 highlights
Interior Comfort Bluetooth Audio NOTE l l l l Some Bluetooth audio devices need a certain amount of time before the " " symbol is displayed. If the programming failed, "Err" flashes for three seconds then it returns to "PAIR DEVICE". Programming cannot be performed while the vehicle is moving. If you attempt to perform programming while the vehicle is moving, "PAIR DISABLE" is displayed and it returns to "PAIR DEVICE". If seven Bluetooth audio devices have already been programmed to the vehicle, programming cannot be performed and "MEMORY FULL" is displayed. Delete one programmed device to program another one. 6. When the programming is completed, " " and "PAIR SUCCESS" are displayed after about 10-30 seconds, after which "PAIR SUCCESS" continues to be displayed for three seconds, and then the unit returns to the normal display. NOTE l l l l Programming a Bluetooth audio device which does not have a PIN code (4 digits) 1. Using the audio control dial, select the pairing program mode "PAIR DEVICE" in the "BT SETUP" mode. (Refer to "Bluetooth audio set up" for details.) 2. Press the audio control dial to determine the mode. After "ENTER PIN" is displayed on the information display for 3 seconds, "PIN 0000" is displayed and the PIN code can be input. 3. Press the audio control dial while "PIN 0000" is displayed. "PAIRING" flashes on the display. 4. Operate the Bluetooth audio device and set it to the program mode while "PAIRING" is flashing. 5. As the Bluetooth audio device requires a PIN code, input "0000". l If pairing cannot be completed, try "1234" instead. Refer to the owner's manual of your mobile device for the right PIN code. Some Bluetooth audio devices need a certain amount of time before the " " symbol is displayed. If the programming failed, "Err" flashes for three seconds then it returns to "PAIR DEVICE". Programming cannot be performed while the vehicle is moving. If you attempt to perform programming while the vehicle is moving, "PAIR DISABLE" is displayed and it returns to "PAIR DEVICE". If seven Bluetooth audio devices have already been programmed to the vehicle, programming cannot be performed and "MEMORY FULL" is displayed. Delete one programmed device to program another one. 6-67