2010 Mazda MAZDA3 Owner's Manual - Page 212
2010 Mazda MAZDA3 Manual
Page 212 highlights
Driving Your Mazda Switches and Controls Windshield Wipers and Washer The ignition must be switched ON. NOTE Because heavy ice and snow can jam the wiper blades, the wiper motor is protected from motor breakdown, overheating and possible fire by a circuit breaker. This mechanism will automatically stop operation of the blades, but only for about 5 minutes. If this happens, turn off the wiper switch and park off the right-of-way, and remove the snow and ice. After 5 minutes, turn on the switch and the blades should operate normally. If they do not resume functioning, consult an Authorized Mazda Dealer as soon as possible. Drive to the side of the road and park off the right-ofway. Wait until the weather clears before trying to drive with the wipers inoperative. WARNING Use only windshield washer fluid or plain water in the reservoir: Using radiator antifreeze as washer fluid is dangerous. If sprayed on the windshield, it will dirty the windshield, affect your visibility, and could result in an accident. Only use windshield washer fluid mixed with anti-freeze protection in freezing weather conditions: Using windshield washer fluid without anti-freeze protection in freezing weather conditions is dangerous as it could freeze on the windshield and block your vision which could cause an accident. In addition, make sure the windshield is sufficiently warmed using the defroster before spraying the washer fluid. qWindshield Wipers Type A (With INT position) Turn the wipers on by pulling the lever down. INT ― Intermittent LO ― Low speed HI ― High speed For a single wiping cycle, press the lever up to MIST. MIST ― Mist 5-62