2010 Mazda MAZDA3 Owner's Manual - Page 259

Interior Comfort Audio System When the seek tuning button ( ) is pressed (about 1.5 seconds), playback starts from the beginning of the current program. When the seek tuning button ( ) is pressed twice, playback starts from the beginning of the previous program. When the seek tuning button ( ) is pressed for about 1.5 seconds or longer, the program is reversed while the button is being pressed. When the seek tuning button ( ) is pressed (about 1.5 seconds), playback starts from the beginning of the next program. When the seek tuning button ( ) is pressed (about 1.5 seconds) while the last program is being played, the instant replay mode is cancelled. When the seek tuning button ( ) is pressed for 1.5 seconds or longer, the program is fast-forwarded while the button is being pressed. When pressing and holding the button until the end of the program, the instant replay mode is cancelled. When the instant replay button is pressed again, playback is paused, or playback starts if it has been paused. Instant replay (PAUSE) If the instant replay button is pressed while the instant replay mode is off, instant replay mode is turned on in a paused condition (PAUSE). Press the instant replay button again to resume playback from the point at which it was paused. NOTE l Displaying the SIRIUS ID (ESN) When the ESN button is pressed for 1.5 seconds or longer, a 12-digit Electronic Serial Number (ESN) for the SIRIUS tuner is displayed. (If the SIRIUS ID (ESN) for the tuner does not display) FAIL" is displayed after If "ESN pressing the ESN button for 1.5 seconds or longer, contact an Authorized Mazda Dealer. Initialization of ID code If the registered ID code is forgotten, return the ID code to the default [0000] by performing the following steps: Setting condition: SAT mode NOTE (scan button) refers to the operation for an Indash CD changer-equipped vehicle. The auto memory button refers to the operation for a CD player-equipped vehicle. (Master code input preparation) 1. Hold the auto memory button (scan button), then press channel preset button 4, hold both buttons together for 1.5 seconds. 2. "ENTER PIN" appears for three seconds which indicates that it is in code input mode. 3. "SR1 - - - -" appears, which indicates that it is ready for code input. (Master code input) 4. Input the master code using the channel preset buttons 1-4. (The master code is already set at the time of factory shipment.) l If the channel is changed, the instant replay buffer data is deleted. After turning on the power and switching to SIRIUS digital satellite radio mode, the instant replay mode is not available for several seconds after changing channels. 6-41