2010 Mazda MAZDA3 Owner's Manual - Page 261
2010 Mazda MAZDA3 Manual
Page 261 highlights
Interior Comfort Audio System (Verification with the registered ID code) 5. Determine the input code by pressing the auto memory button (scan button). 6. If it does not match with the previously registered code, "SR1 Err" is displayed and then it returns to "SR1 7. If it matches with the previously registered code, "ENTER PIN" appears again and it switches to code input mode. 8. "SR1 - - - -" appears, and it is ready for input of the new ID code. (New ID code input) 9. Input the new ID code using channel preset buttons 1-4. Example: If "1234" is input as the new code, "SR1 1234" is displayed. (New ID code input determination) 10. Determine the new ID code which has been input by pressing the auto memory button (scan button). 11. "PIN CHANGED" appears for three seconds which indicates that the new ID code input has been completed. 12. It returns to the former display. NOTE l NOTE l l If the registered ID code is forgotten, return the ID code to the default [0000]. (See "INTIALIZATION OF ID CODE" section) (scan button) refers to the operation for an In-dash CD changer-equipped vehicle. The auto memory button refers to the operation for a CD player-equipped vehicle. (Locking a channel) 1. Select a channel to be locked by turning the manual tuning dial. Example: Select channel 100 (Registered ID code input preparation) 2. Hold the auto memory button (scan button), then press channel preset button 6, hold both buttons together for 1.5 seconds. 3. "ENTER PIN" appears for three seconds which indicates that it is in code input mode. 4. "SR1 - - - -" appears which indicates that it is ready for code input. (Registered ID code input) 5. Input the registered ID code using channel preset buttons 1-4. Example: If the registered ID code is "2323", input "2323". At this time "SR1 2323" is displayed. (Registered ID code input determination) 6. Determine the code which has been input by pressing the auto memory button (scan button). 7. If it does not match the registered code, "SR1 Err" is displayed and then it returns to "SR1 - - - -". l If an ID code is not input for ten seconds, "Err" is displayed and it returns to the former display. Channel preset buttons 1, 2, 3, 4 and the auto memory button (scan button) are used for input of the ID code. Buttons 5 and 6 cannot be used. Individual channel locking If a channel is locked, the channel is muted. 6-43