2010 Mazda MAZDA3 Owner's Manual - Page 262
2010 Mazda MAZDA3 Manual
Page 262 highlights
Interior Comfort Audio System 8. If it matches the registered code, "SR1 LOCK" appears for three seconds which indicates that the code input has been completed. 9. "SR1 LOCK 100" appears which indicates that the parental lock is activated. At this time, mute is on and no sound is heard. NOTE l 4. "SR1 - - - -" appears, which indicates that it is ready for code input. (Registered ID code input) 5. Input the registered ID code using channel preset buttons 1-4. Example: When the registered ID code is "2323", input "2323". At this time "SR1 2323" is displayed. NOTE If "Err" is displayed, go to the "INITIALIZATION OF ID CODE" section to reset the ID code to [0000]. l If an ID code is not input for ten seconds, "Err" is displayed and it returns to the former display. Channel preset buttons 1, 2, 3, 4 and the auto memory button (scan button) are used for input of the ID code. Buttons 5 and 6 cannot be used. (Registered ID code input determination) 6. Determine the input code by pressing the auto memory button (scan button). 7. If it does not match the registered code, "SR1 Err" is displayed and then it returns to "SR1 8. If it matches the registered code, "SR1 UNLOCK" appears for three seconds which indicates that the code input has been completed. 9. "SR1 100" appears which indicates that the parental lock is off. At this time, sound is heard. NOTE l Lock cancellation Setting condition: SAT mode NOTE (scan button) refers to the operation for an Indash CD changer-equipped vehicle. The auto memory button refers to the operation for a CD player-equipped vehicle. (Releasing a locked channel) 1. Select a channel to be released by turning the manual tuning dial. Example: Select the locked channel (i.e. 100). At this time, "SR1 LOCK 100" is displayed. (Registered ID code input preparation) 2. Hold the auto memory button (scan button), then press channel preset button 6, hold both buttons together for 1.5 seconds. 3. "ENTER PIN" appears for three seconds which indicates that it is in code input mode. l If an ID code is not input for ten seconds, "Err" is displayed and it returns to the former display. Channel preset buttons 1, 2, 3, 4 and the auto memory button (scan button) are used for input of the ID code. Buttons 5 and 6 cannot be used. 6-44