2010 Mazda MAZDA3 Owner's Manual - Page 56
2010 Mazda MAZDA3 Manual
Page 56 highlights
Essential Safety Equipment Child Restraint qLATCH Child-Restraint System Installation Procedure (Rear Center Seat) The LATCH lower anchors at the center of the rear seat are much further apart than the sets of LATCH lower anchors for child-restraint system installation at other seating positions. Child-restraint systems with rigid LATCH attachments cannot be installed on the center seating position. Some LATCH equipped child-restraint systems can be placed in the center position and will reach the nearest LATCH lower anchors which are 400 mm (15.75 in) apart. LATCH compatible child-restraint systems (with attachments on belt webbing) can be used at this seating position only if the child-restraint system manufacturer's instructions state that the child-restraint system can be installed to LATCH lower anchors that are 400 mm (15.75 in) apart. Do not attach two child-restraint systems to the same LATCH lower anchor. If your childrestraint system has a tether, it must also be used for your child's optimum safety. WARNING Use the tether and tether anchor only for a child-restraint system: Using the tether or tether anchor to secure anything but a child-restraint system is dangerous. This could weaken or damage the tether or tether anchor and result in injury. Always attach the tether strap to the correct tether anchor position: Attaching the tether strap to the incorrect tether anchor position is dangerous. In a collision, the tether strap could come off and loosen the child-restraint system. If the childrestraint system moves it could result in death or injury to the child. 1. Make sure the seatback is securely latched by pushing it back until it is fully locked. 2. Expand the area between the seat bottom and the seatback slightly to verify the locations of the LATCH lower anchors. NOTE The markings above the LATCH lower anchors indicate the locations of LATCH lower anchors for the attachment of a child-restraint system. 2-42