2010 Mercedes R-Class Owner's Manual - Page 137

251_AKB; 4; 52, en-US d2ureepe, 2009-03-23T09:22:52+01:00 - Seite 135 Version: 2.11.8.1 Control system RLicense RSide 135 plate lamps marker lamps fog lamps RFront RParking RTail lamps plate lamps lamps marker lamps RLicense RSide For more information on the daytime running lamp mode, see (Y page 99). For safety reasons, changing the setting for the daytime running lamp mode is not possible while the vehicle is in motion. The following message appears in the multifunction display: Settings can only be made with engine off. For safety reasons, resetting all the functions of all submenus to the factory settings while driving (Y page 131) will not deactivate the daytime running lamp mode. Switching locator lighting on or off With the locator lighting feature activated, the exterior lamp switch in position à and the interior lighting in automatic mode, the following lamps will come on during darkness when the vehicle is unlocked using button % on the SmartKey: RParking lamps RTail X Press button W or X to switch the locator lighting function On or Off. X Turn the exterior lamp switch to position à when exiting the vehicle. The locator lighting feature is activated. Switching night security illumination (Headlamps delayed shut-off feature) on or off Use this function to set whether you would like the exterior lamps to remain on for 15 seconds during darkness after exiting the vehicle and closing all doors. lamps Z Controls in detail X Press button W or X to switch the daytime running lamp mode On or Off. With daytime running lamp mode switched on and the exterior lamp switch in position $ or Ã, the low-beam headlamps are switched on when the engine is running. In low ambient light conditions the following lamps will come on additionally: The locator lighting goes out when the driver's door is opened. If you do not open the driver's door after unlocking the vehicle with the SmartKey, the lamps will go out automatically after approximately 40 seconds. X Press button V or U repeatedly until the Settings menu appears in the multifunction display. X Press button &. X Move the selection marker with button W or X to the Lighting submenu. X Press button & or * repeatedly until the message Surround Lighting Function appears in the multifunction display. The selection marker is on the current setting.