2010 Mercedes R-Class Owner's Manual - Page 186

251_AKB; 4; 52, en-US d2ureepe, 2009-03-23T09:22:52+01:00 - Seite 184 Version: 2.11.8.1 184 Panorama roof with power tilt/sliding panel Panorama roof with power tilt/ sliding panel Extending and retracting the roller sunblinds The roller sunblinds only operate with the tilt/ sliding panel closed. The front and rear roller sunblind cannot be operated individually. Opening and closing the panorama roof with power tilt/sliding panel G Observe Safety notes, see page 55. When opening or closing the tilt/sliding panel, make sure there is no danger of anyone being harmed by the opening/closing procedure. The tilt/sliding panel is equipped with the express operation and automatic reversal function. If the movement of the tilt/sliding panel is blocked during the closing procedure, the tilt/sliding panel will stop and open slightly. The tilt/sliding panel operates differently when the roof panel switch is pressed and held. See the "Closing when the tilt/sliding panel is blocked" section in this chapter for details. The opening/closing procedure of the tilt/ sliding panel can be immediately halted by releasing the roof panel switch or, if the roof panel switch was moved past the resistance point and released, by moving the roof panel switch in any direction. G Warning! Controls in detail G Warning! When extending the roller sunblinds, make sure no one is in danger of being injured by the extending procedure. The extending of the roller sunblinds can be immediately halted by releasing the switch. Roof panel switch : Retracting ; Retracting = Extending X X Switch on the ignition. Retracting/Extending: Move the roof panel switch to the resistance point in the required direction of arrow :, ; or = until the roller sunblinds have reached their desired position. X Express retracting: Push the roof panel switch past the resistance point in direction of arrow ; and release. The roller sunblinds retract completely. X Stopping during express retracting: Move the roof panel switch in any direction. The panorama roof with tilt/sliding panel is made out of glass. In the event of an accident, the glass may shatter. This may result in an opening in the roof. In a vehicle rollover, occupants not wearing their seat belts or not wearing them properly may be thrown out of the opening. Such an opening also presents a potential for injury for occupants wearing their seat belts properly as entire body parts or portions of them may protrude from the passenger compartment. G Warning! ! To avoid damaging the seals, do not transport any objects with sharp edges which can stick out of the tilt/sliding panel. Do not open the tilt/sliding panel if there is snow or ice on the roof, as this could result in malfunctions.