2010 Mercedes R-Class Owner's Manual - Page 217

251_AKB; 4; 52, en-US d2ureepe, 2009-03-23T09:22:52+01:00 - Seite 215 Version: 2.11.8.1 Useful features If you live in Canada or if you are having difficulties programming a gate operator (regardless of where you live) by using the programming procedures, replace step 4 with the following: X Step 4: Press and hold the signal transmitter button (;, = or ?). Do not release this button until it has been successfully trained. X While still holding down the signal transmitter button (;, = or ?), "cycle" your hand-held remote control button B as follows: Press and hold button B for 2 seconds, then release it for 2 seconds, and again press and hold it for 2 seconds. Repeat this sequence on the hand-held remote control until the frequency signal has been learned. Upon successful training, indicator lamp : will flash slowly and then rapidly after several seconds. X Proceed with programming step 5 and step 6 to complete. X 215 Operation of integrated remote control X X Switch on the ignition. Select and press the appropriate integrated signal transmitter button (;, = or ?) to activate the remote controlled device. The integrated remote control transmitter continues to send the signal as long as the button is pressed - up to 20 seconds. Erasing the integrated remote control memory i If you sell your vehicle, erase the codes of all three channels. X X i Upon completion of programming the integrated remote control, make sure you retain the hand-held remote control that came with the garage door opener, gate operator or other device. You may need it for use in other vehicles, for future programming of an integrated remote control, or simply for continued use as a hand-held remote control to operate the respective device in other situations. Reprogramming a single signal transmitter button To program a device using a signal transmitter button previously trained, follow these steps: Switch on the ignition. Simultaneously press and hold outer signal transmitter buttons ; and ?, for approximately 20 seconds, until indicator lamp : flashes rapidly. Do not hold for longer than 30 seconds. The codes of all three channels are erased. Programming tips If you are having difficulty programming the integrated remote control, here are some helpful tips: RCheck the frequency of hand-held remote control A (typically located on the reverse side of the remote). The integrated remote Z Controls in detail Switch on the ignition. X Press and hold the desired signal transmitter button (;, = or ?). Do not release the button. Indicator lamp : will begin to flash after 20 seconds. X Without releasing the signal transmitter button, proceed with programming starting with step 3.