2010 Mercedes R-Class Owner's Manual - Page 187
2010 Mercedes R-Class Manual
Page 187 highlights
251_AKB; 4; 52, en-US d2ureepe, 2009-03-23T09:22:52+01:00 - Seite 185 Version: 2.11.8.1 Panorama roof with power tilt/sliding panel ! Please keep in mind that weather conditions can sometimes change rapidly. Make sure to close the tilt/sliding panel when leaving the vehicle. If water enters the vehicle interior, vehicle electronics could be damaged which is not covered by the Mercedes-Benz Limited Warranty. i Express opening is not available when the tilt/sliding panel is raised. The tilt/sliding panel must be closed first. i When the tilt/sliding panel is open, resonance noises may result in addition to the usual wind noises. They are caused by minimal pressure changes in the passenger compartment. To reduce or eliminate these noises, change the position of the tilt/ sliding panel or open a window slightly. Raising X 185 Raising manually: Press and hold the roof panel switch in direction of arrow :. X Release the roof panel switch when the desired position is reached. Roof panel switch : Raising ; Opening = Closing Closing X The tilt/sliding panel only operates with the roller sunblinds retracted. Closing manually: Pull and hold the roof panel switch in direction of arrow =. X Release the roof panel switch when the desired position is reached. Closing when the tilt/sliding panel is blocked i You can also open or close the tilt/sliding panel using the SmartKey, see "Summer opening feature" (Y page 108) or see "Convenience closing feature" (Y page 108). X G Warning! Switch on the ignition. Make sure that nobody can become trapped and be seriously or even fatally injured when closing the tilt/sliding panel without automatic reversal function. Opening X Opening manually: Press and hold the roof panel switch to the resistance point in direction of arrow ;. X Release the roof panel switch when the desired position is reached. X Express operation: To open the tilt/ sliding panel completely, press the roof panel switch past the resistance point in direction of arrow ; and release. X Stopping during express operation: Move the roof panel switch in any direction. If the movement of the tilt/sliding panel is blocked during the closing procedure (e.g. by ice or pollution), the tilt/sliding panel will stop and open slightly. X Immediately after the tilt/sliding panel has stopped and opened because it was blocked, pull and hold the roof panel switch in direction of arrow = until the tilt/sliding panel is fully closed. Z Controls in detail
![](/manual_guide/autos/2010-mercedes-rclass-owners-manual-85c3552/187.png)