2010 Mercedes R-Class Owner's Manual - Page 83
2010 Mercedes R-Class Manual
Page 83 highlights
251_AKB; 4; 52, en-US d2ureepe, 2009-03-23T09:22:52+01:00 - Seite 81 Version: 2.11.8.1 Seats Position 1 X 81 Seats Safety notes In order to avoid possible loss of vehicle control the following must be done before the vehicle is put into motion: Rseat Press the KEYLESS-GO start/stop button once. This supplies power for some electrical consumers, such as radio functions. G Warning! adjustment restraint adjustment wheel adjustment of seat belts Rhead Rsteering Rrear view mirror adjustment Ignition (or position 2) X Rfastening Press the KEYLESS-GO start/stop button twice. This supplies power for all electrical consumers. All lamps (except low-beam headlamp indicator lamp, high-beam headlamp indicator lamp, and turn signal indicator lamps unless activated) in the instrument cluster come on. If a lamp in the instrument cluster fails to come on when the ignition is switched on, have it checked and replaced if necessary. If a lamp in the instrument cluster remains on after starting the engine or comes on while driving, refer to "Lamps in instrument cluster" (Y page 299). Do not adjust the driver's seat while driving. Adjusting the seat while driving could cause the driver to lose control of the vehicle. Never ride in a moving vehicle with the seat backrest in an excessively reclined position as this can be dangerous. You could slide under the seat belt in a collision. If you slide under it, the seat belt would apply force at the abdomen or neck. That could cause serious or fatal injuries. The seat backrest and seat belts provide the best restraint when the wearer is in a position that is as upright as possible and seat belts are properly positioned on the body. G Warning! i If you now press the KEYLESS-GO start/ stop button once, the power supply is again switched off. G Warning! Your seat must be adjusted so that you can correctly fasten your seat belt. Observe the following points: RAdjust the seat backrest until your arms are slightly angled when holding the steering wheel. RAdjust the seat to a comfortable seating position that still allows you to reach the accelerator/brake pedal safely. The position should be as far back as possible with the driver still able to operate the controls properly. Z Controls in detail i If you now press the KEYLESS-GO start/ stop button Ronce more, the ignition (position 2) is switched on Rtwice more the power supply is again switched off