2010 Mercedes R-Class Owner's Manual - Page 81

251_AKB; 4; 52, en-US d2ureepe, 2009-03-23T09:22:52+01:00 - Seite 79 Version: 2.11.8.1 Starter switch positions the door-mounted remote tailgate switch. Monitor the closing procedure carefully to make sure no one is in danger of being injured. To interrupt the closing procedure, press or pull the door-mounted remote tailgate switch. X 79 Press and hold the tailgate closing switch in the tailgate (Y page 77) until you hear a short acoustic signal. The opening height of the tailgate is limited. The tailgate will now stop at the stored position when opened. If the tailgate comes into contact with an object while closing, the closing procedure is stopped and the tailgate reopens. This may happen if luggage has been piled too high, for example. X Turn the SmartKey in the starter switch to position 1 or 2. X Press remote tailgate opening/closing switch : until the tailgate begins to close. While the tailgate is closing an acoustic warning sounds. X Starter switch positions SmartKey G Observe Safety notes, see page 55. Interrupting the closing procedure: Press or pull remote tailgate opening/ closing switch :. Limiting opening height of tailgate You can limit the opening height of the tailgate in the upper opening range. This can be useful, for example, when the space above the tailgate is not sufficient. Activating X Open the tailgate: Pull on handle (Y page 75) or press and hold button F on the SmartKey until the tailgate opens. X Stop opening procedure: When the tailgate is in the desired position, press tailgate closing switch (Y page 77) or pull on handle once more. X You can also press or pull the remote tailgate opening/closing switch (Y page 78) to stop the opening procedure. Starter switch g For removing SmartKey 1 Power supply for some electrical consumers, e.g. radio 2 Ignition (power supply for all electrical consumers) and driving position 3 Starting position When you switch on the ignition, all lamps (except low-beam headlamp indicator lamp, high-beam headlamp indicator lamp, and turn signal indicator lamps unless activated) in the instrument cluster come on. If a lamp in the instrument cluster fails to come on when the ignition is switched on, have it checked and replaced if necessary. If a lamp in the instrument cluster remains on after starting the engine or comes on while driving, refer to "Lamps in instrument cluster" (Y page 299). Z Controls in detail Deactivating X Press and hold the tailgate closing switch in the tailgate (Y page 77) until you hear two short, consecutive acoustic signals.