2014 Nissan Titan Crew Cab Owner's Manual - Page 215

To adjust Bass, Treble, Fade and Balance, press the MENU button until the desired mode appears in the display. Press the SEEK button to adjust Bass and Treble to the desired level. You can also use the SEEK button to adjust Fade and Balance modes. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. Once you have adjusted the sound quality to the desired level, press the MENU button repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 10 seconds. NOTE: If the clock is enabled, pressing the MENU button will change the mode as follows: BAS → TRE → FAD → BAL → CLOCK → Hour adjustment → Minute adjustment → Audio → BAS For more information on setting the clock, see "Clock set" later in this section. Clock operation Press the MENU button until CLOCK is displayed; use the SEEK button to turn the clock display on (CLK ON) or off (CLK OFF). Clock set If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK ON mode. Press the MENU button repeatedly until CLOCK is displayed. Use the SEEK button to enable CLK ON mode. 1. Press the MENU button repeatedly until CLOCK mode appears; press the SEEK button until CLK ON appears. 2. Press the MENU button again; the hours will start flashing. 3. Press the SEEK button adjust the hour. or to Resetting the time Hold the MENU button down and then press the TUNE/SEEK button; the time will reset as follows: ● If the displayed minutes before the reset are in the range of :00 - :29, the hour displayed before the reset will stay the same and the minutes will be reset to :00. ● If the displayed minutes before the reset are in the range of :30 - :59, the hour displayed before the reset will advance by one hour and the minutes will be reset to :00. For example, if the MENU button and the TUNE/SEEK button are pressed while the time displayed is between 8:00 and 8:29, the display will be reset to 8:00. If the buttons were pressed while the time was between 8:30 and 8:59, the display will be reset to 9:00. At the same time the display will return to the audio. 4. Press the MENU button again; the display will switch to the minute adjustment mode. 5. The minutes will start flashing. Press SEEK button or to adjust the minutes. 6. Press the MENU button again to exit the clock set mode. The display will return to the regular clock display after 10 seconds, or press the MENU button again to return to the regular clock display. FM/AM radio operation FM·AM button: Press the FM·AM button to change from AM ←→ FM reception. The FM stereo indicator, ST, illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. 4-44 Monitor, climate, audio, phone and voice recognition systems