3M MP180 Operating Guide - Page 11
Installing and Charging the Projector Battery, Removing the Protective Film, Install Battery
View all 3M MP180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English 3M™ Pocket Projector MP180 Installing and Charging the Projector Battery Removing the Protective Film When the projector is shipped, there is a protective film between the battery and the battery contacts on the projector. Remove the protective film by removing the battery and the protective film, discard the film and finally install the battery. Install Battery The 3M projector comes with a rechargeable battery. The battery should be fully charged before using the projector with the battery. To install the battery, orient the contacts on the battery toward the contacts on the projector, insert the end farthest from the battery latch first, then push down until the battery clicks into place. The projector will automatically turn on. Remove Battery To remove the battery, slide the battery latch away from the battery and then lift the battery out, starting at the end closest to the latch. Important Note: Use only the 3M-specified battery: 78-6972-0026-5. Note: The projector will turn on automatically when the battery is installed. © 2011 3M. All Rights Reserved. 11