Aastra OpenCom 510 User Guide - Page 101
Codes for IP Configuration, Forced logoff of another user by the administrator, Configurator
View all Aastra OpenCom 510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Configuration Configuring the OpenCom 510 Forced logoff of another user by the administrator The configuration of the system can always only be edited by one user. Working on the configuration in parallel is not possible. This ensures that no configuration conflicts arise. If the user "Administrator" logs in and another user with administration rights is already logged in, then the administrator can forcibly log the other user off in order to configure. This functionality, for example can be used, when configuring remotely, when a user has forgotten to log out. In order to forcibly log a user off: 1. The "Administrator" user logs on with the administration password. 2. They open the Configurator. A message shows which user is currently configuring the system. 3. The administrator clicks on the Take over config rights button. The other user can make no further modifications of the configuration. 9.2.8 Codes for IP Configuration The IP configuration of the OpenCom 510 is performed on the Web console in the Configurator, in the NET Configuration: LAN menu. In the event that the IP configuration of the OpenCom 510 has to be changed and access via the Web console is not possible, you can also use a code digit procedure to change these basic settings. Entry can be made from an analogue telephone, an ISDN telephone and from system telephones. Set IP address H *182 Z (system PIN) * Z (www) * Z (xxx) * Z (yyy) * Z (zzz) # Set NET mask H *183 Z (system PIN) * Z (www) * Z (xxx) * Z (yyy) * Z (zzz) # 99