Adaptec 44300 User Guide - Page 55

Insert the other floppy disks when prompted., is the controller number.

Get Adaptec 44300 PDF manuals and user guides View all Adaptec 44300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 55 highlights

Chapter 10: Solving Problems l 55 5 Power off your computer, disconnect the power cord, then open the cabinet following the manufacturer's instructions. 6 Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0 flash connector. 7 Reconnect the power cord, power on your computer, then boot to the floppy disk containing the AFU.exe file (see Step 3). 8 At the prompt, type a:\afu update /c x, where x is the controller number. 9 Insert the other floppy disks when prompted. 10 When the flash is complete, power off your computer, disconnect the power cord, then remove the jumper. 11 Close the computer cabinet, reconnect the power cord, then power on your computer. The controller should boot correctly.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
Chapter 10: Solving Problems
l 55
5
Power off your computer, disconnect the power cord, then open the cabinet following the
manufacturer’s instructions.
6
Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
flash connector.
7
Reconnect the power cord, power on your computer, then boot to the floppy disk
containing the AFU.exe file (see
Step 3
).
8
At the prompt, type
a:\afu update /c x,
where
x
is the controller number.
9
Insert the other floppy disks when prompted.
10
When the flash is complete, power off your computer, disconnect the power cord, then
remove the jumper.
11
Close the computer cabinet, reconnect the power cord, then power on your computer.
The controller should boot correctly.