Brother International DS-920DW Users Guide - Page 74

Calibration was successful, Calibration failed, message appears on your

Get Brother International DS-920DW PDF manuals and user guides View all Brother International DS-920DW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 74 highlights

Scanner Calibration f Hold the edges of the Calibration Sheet and insert it into the feeder slot as shown below. Click OK. 9 NOTE Hold only the edges of the Calibration Sheet and be careful not to touch the white or black area. Leaving marks or fingerprints on this sheet can cause errors in calibration. g Scanning starts automatically. h After the Calibration Sheet is scanned, the Calibration was successful message appears on your screen, indicating that calibration finished successfully. Click OK to end calibration. NOTE If the Calibration failed message appears on your screen, remove the Micro USB cable from your computer. Reconnect the Micro USB cable to the computer and perform the calibration again. 66

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
Scanner Calibration
66
9
f
Hold the edges of the Calibration Sheet and insert it into the feeder slot as shown below.
Click
OK
.
NOTE
Hold only the edges of the Calibration Sheet and be careful not to touch the white or black area. Leaving
marks or fingerprints on this sheet can cause errors in calibration.
g
Scanning starts automatically.
h
After the Calibration Sheet is scanned, the
Calibration was successful
message appears on your
screen, indicating that calibration finished successfully. Click
OK
to end calibration.
NOTE
If the
Calibration failed
message appears on your screen, remove the Micro USB cable from your
computer. Reconnect the Micro USB cable to the computer and perform the calibration again.