Brother International Innov-is NQ550PRW Operation Manual - Page 23
Basic operations
View all Brother International Innov-is NQ550PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Winding/Installing the Bobbin While holding the thread near the spool with your right g hand, as shown, pull the thread with your left hand, and then pass the thread behind the thread guide cover and to the front. 1 While holding the thread with your left hand, wind the j thread that was pulled out clockwise around the bobbin five or six times with your right hand. B GETTING READY 1 Thread guide cover Pass the thread under the thread guide plate, and then h pull it to the right. Note • Make sure that the thread between the spool and the bobbin is pulled tight. • Be sure to wind the thread clockwise around the bobbin, otherwise the thread will become wrapped around the bobbin winder shaft. Pass the end of the thread through the guide slit in the k bobbin winder seat, and then pull the thread to the right to cut it. 1 1 Thread guide plate Pass the thread under the hook on the thread guide, i and then wind it counterclockwise under the pretension disk. 1 2 1 1 Guide slit in bobbin winder seat (with built-in cutter) CAUTION • Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out. Slide the sewing speed controller to the right. l 3 1 Thread guide 2 Pretension disk 3 Pull it in as far as possible Note • Make sure that the thread passes under the pretension disk. 1 1 Speed controller Note • Bobbin winding speeds may vary depending on type of thread being wound on bobbin. Basic operations B-15