Brother International PT-9500PC Quick Setup Guide - English and Spanish - Page 7

GENERAL PRECAUTIONS ■ P-touch 9500PC ● The PT-9500PC is a precision machine. Do not drop the PT-9500PC or subject it to strong shocks. ● Do not grab and lift the PT-9500PC by the tape compartment cover. The cover could come off and the PT-9500PC could drop and be damaged. ● The PT-9500PC may malfunction if left near a television, radio, etc. Do not install the PT-9500PC near any machines that will cause electromagnetic interference. ● Keep the PT-9500PC out of direct sunlight. ● Do not use the PT-9500PC in extremely dusty areas, in areas with high temperatures or high humidity, or in areas where the PT-9500PC may freeze. The PT-9500PC may malfunction or stop operating. ● Do not clean the PT-9500PC with thinner, benzene, alcohol, or other organic solvents. The PT-9500PC finish may come off and the PT-9500PC case may be damaged. If dirty, clean the PT-9500PC with a soft, dry cloth. ● Do not leave any rubber or vinyl on top of the PT-9500PC for an extended period. The PT-9500PC may be stained. ● Do not place any heavy objects or objects containing water on top of the PT-9500PC. If water or any foreign object enters the PT-9500PC, contact the retail outlet where the PT-9500PC was purchased or your local authorized service center. If you continue to use the PT-9500PC with water or a foreign object in the PT-9500PC, the PT-9500PC may be damaged or personal injury could result. ● Do not touch the cutter. Personal injury could result. Take special care when the tape compartment cover is open when changing the tape. ● Do not insert any objects into or block the label outlet, AC adapter jack, USB port, or serial port. ● Do not touch any metal parts near the print head. The print head is very hot during use and immediately after use. Do not touch directly with your hands. ● Use only the interface cables (USB interface cable, serial interface cable) included with the PT-9500PC. ● Use only genuine Brother accessories and supplies. Do not use any unauthorized accessories or supplies. ■ AC adapter ● Use only the AC adapter included with the PT-9500PC. ● If the PT-9500PC will not be used for an extended period, remove the power supply cord from the electrical outlet. ■ Tape (tape cassette) ● Use only Brother TZ tapes or Brother/Avery AV labels with this machine. Do not use tapes that do not have the or mark. ● Do not pull on the tape, otherwise the tape cassette may be damaged. ● If the label is attached to a wet, dirty, or oily surface, it may peel off easily. Before affixing the label, clean the surface where it will be affixed. ● Depending on the environmental conditions and the material, condition, roughness, and shape of the affixing surface, part of the tape may not be affixed properly or the label may peel off. ● In order to test the adhesive strength of the label or before using the label where safety is a particular concern, test the label by affixing a small piece of it to an inconspicuous area of the intended surface. ● If the label is used outdoors, ultraviolet rays, wind, and rain may cause the color of the label to fade and the ends of the label to peel off. ● Markings made with oil-based or water-based ink may be visible through a label affixed over them. To hide the markings, use two labels layered on top of each other or use a dark-colored label. ● Do not use empty tape cassettes. ● Do not expose the tape cassettes to direct sunlight, high temperatures, high humidity, or dust. Store in a cool, dark place. Use the tape cassettes soon after opening the tape cassette package. ● Note that Brother Co., Ltd. does not assume responsibility for any damage, etc. arising from failure to follow the precautions listed. ● Avery® is a registered trademark of AVERY DENNISON CORPORATION. 6