Canon FS-4 User Guide - Page 15

Installing and Removing the Battery Pack

Get Canon FS-4 - FOCUS FireStore Pro PDF manuals and user guides View all Canon FS-4 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Reels Screen (FS-4Pro only) - allows selected clips to be marked for placement in particular Reels Folders. Installing and Removing the Battery Pack Before operating the FS-4, install the battery as follows: Step 1: Turn the FS-4 unit over, so that the back is facing you as shown in the following illustration. Battery Latch Battery Compartment Step 2: Slide the battery pack into the compartment. Make sure the contacts on the side meet the contacts on the inside of the unit. Step 3: Make sure the battery latch clicks into place. You can immediately use the FS-4 unit if you attach the AC power cord with or without the battery pack installed. You must charge the battery until the battery status LED indicates the unit is charged before you can use the FS-4 with the battery. The Charge LED on the top of the FS-4 lights to show the battery is charging. A flat battery on charge will take 2-3 hours to charge with the unit powered off. The included battery will supply power to the FS-4 for about 90 minutes while in continuous Record or Playback mode. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
11
Reels Screen
(FS-4Pro only) - allows selected clips to be marked for
placement in particular Reels Folders.
Installing and Removing the Battery Pack
Before operating the FS-4, install the battery as follows:
Step 1:
Turn the FS-4 unit over, so that the back is facing you as
shown in the following illustration.
Step 2:
Slide the battery pack into the compartment. Make sure
the contacts on the side meet the contacts on the inside
of the unit.
Step 3:
Make sure the battery latch clicks into place.
You can immediately use the FS-4 unit if you attach the AC power
cord with or without the battery pack installed.
You must charge the battery until the battery status LED indicates the
unit is charged before you can use the FS-4 with the battery. The
Charge LED on the top of the FS-4 lights to show the battery is charg-
ing. A flat battery on charge will take 2-3 hours to charge with the unit
powered off.
The included battery will supply power to the FS-4 for about 90 min-
utes while in continuous Record or Playback mode.
Battery Latch
Battery
Compartment