Canon REALiS LCOS WUX6600Z WUX7000Z WUX6600Z WUX5800Z Users Manual - Page 26

For Safe Use Pay attention to the following points when installing or using the projector. • Be careful of condensation. If the projector is abruptly taken to a warmer location, or if the room temperature rises abruptly, moisture in the air may condense on the lens or mirror and affect projected images. In this case, wait a while and make sure the moisture has evaporated before resuming use. • Do not install the projector in a location where the temperature is high or low. Doing so may cause a malfunction. Ranges for the environment of use and storage are as follows. • Environment of use: 0°C (32°F) to 45°C (113°F), 20% to 85% RH • Storage temperature: -20°C (-4°F) to 60°C (140°F) • When using the projector at altitudes above 2,300 m (7,545.8'): Adjust projector installation settings from the menu (P154). • Install the projector leaving at least 50 cm (1.6') between air intake/exhaust vents and walls on each side of the projector. Leave a gap of at least 2 cm (0.8") from the bottom of the projector. There is an air intake underneath the projector. Failure to leave enough space may trap heat inside the projector and damage it. At least 50 cm (1.6') At least 50 cm (1.6') At least At least 50 cm (1.6') 50 cm (1.6') At least 2 cm (0.8") • Do not place any objects on top of the projector that may change shape or color due to heat. • Do not install the projector near high-voltage electrical power lines or an electrical power source. This may cause malfunction. • Afterimages may occur when the image changes after the same image has been projected for some time. This is due to the nature of the LCD panels and does not indicate a problem. The afterimage will dissipate after a while during normal projection. 24