Canon SX50 Realis Command Codes - Page 15
Error List - projector error codes
UPC - 013803046830
View all Canon SX50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
10. Error List Item Code TYPE Error character string Error description Remedy 1 0001 2 0002 3 0003 e BAD_SEQUENCE e INVALID_COMMAND e INVALID_MODE Communication sequence error Command is invalid (undefined). The designated command cannot be executed in this mode. Wait until the response is received to send the command. Send the correct command. Switch the mode using the REMOTE or LOCAL command. 4 0004 5 0005 e INVALID_FORMAT e NOT_POWER_SUPPLIED The command format is incorrect. Power is not being supplied. Send in the correct command format. Use the POWER ON command to turn on the power. 6 - i BUSY Transition between states or processing is in Wait until the power supply state changes to progress in the SX50. "ON", "OFF", or "PMM". 7 000A e INVALID_PARAMETER The parameter (type) is invalid (undefined). This includes the case when the number of parameters is incorrect. Use the correct parameter(s). 8 000B 9 - e JOB_TIMEOUT SX50 internal processing has timed out. Resend the command. w USER_COMMAND_VERSION_IS_UPDA TED The user command version is being updated. Use GET COMVER to obtain the latest user command version. 10 F001 e SYSTEM (UNKNOWN) 11 E0XX e COMMUNICATION_ERROR An internal error occurred. Resend the command. A communication protocol violation occurred in the projector. Resend the command. 12 200X e INVALID_SOURCE (****) This cannot be executed with the current input source. The current input source is indicated in Change the input source. parentheses. 2010 13 201X 14 - e NO_SIGNAL e INVALID_SIGNAL (****) i BUSY (NOW_SETTING) BUSY i (POWER_MANAGEMENT_READY) i BUSY (INTERNAL_PROCESS) There is no signal input. Input the signal. This cannot be executed with the current input signal. The current input signal is indicated in Change the input signal. parentheses. Signal setting (detection) is in progress. Preparing to switch to power management standby. Wait until the processing is completed. Heavy processing is in progress. 0801 15 0802 e INVALID_VALUE Numerical parameters are invalid or outside the range. Use the RANGE command to obtain the parameter range, and then use a parameter within the range. 1001 e TERMINAL_OUT The input cannot be selected since the terminal is set to output. Use the TERMINAL command to set the terminal to input, and then select the input again. 16 1002 e NO_LOGO_CAPTURED Processing cannot be executed image is not registered. since the user Register the user image. 1003 203X e IP_NOT_AVAILABLE e INVALID_RESOLUTION (***) IP conversion cannot be performed. The input signal resolution is not correct. Change to the correct input signal. Change to the correct resolution of the input signal. ※ The error code is expressed as a four-digit hexadecimal character string. 'X' is a number from '0' to '9' or letter from 'A' to 'F'. ※ Errors with the newer item numbers have higher priority. (When there is more than one error, the highest level error is returned. However, error priority is the same within the same item number.)