Canon imagePROGRAF PRO-2000 series User Manual - Page 120
Using the Roll Unit In Take-Up Mode
View all Canon imagePROGRAF PRO-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Using the Roll Unit In Take-Up Mode Important • For details on the roll paper compatible with winding, see "Paper Information List.". • Before loading the roll paper to be taken up on the roll unit, set the roll unit mode to take-up device on the printer touch screen. (See "Switching Roll Unit Modes.") • The following operation assumes that the roll holder is not installed on the roll unit and that roll paper is not loaded on the roll holder. If the roll holder is installed on the roll unit, first remove the roll holder from the roll unit, and then remove the roll paper loaded on the roll holder. (See "Removing the Lower Roll from the Roll Unit (Option).") (See "Removing Rolls From the Roll Holder.") • Paper winding is possible until the outer diameter of the wound paper is the same as the outer diameter of the holder stopper. • When printing on lightweight paper or without a border, the border of the paper may get wrinkled coming in contact with the roll holder, resulting in poor winding. If these problems occur when winding using a 2-inch core, remove the spacer held in place by 4 hex screws on the roll holder flange, and then wind. 1. Store basket. (See "Storing the Basket.") 2. Push holder stopper lever (A) toward shaft to release lock, and while holding in position (B), remove holder stopper from roll holder. 3. If taking up roll paper whose paper core has an inner diameter of 3 inches (76.2 mm), insert 3-Inch Paper Core Attachment in roll holder and holder stopper. Align the 3-Inch Paper Core Attachment tabs (A) with the holes on the roll holder or holder stopper (B) and insert firmly. 120