Cisco 3524XL Hardware Installation Guide - Page 73
Connecting to a 10/100 Switch Port, Straight-Through Cable Pinouts on B-4.
UPC - 746320224220
View all Cisco 3524XL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Chapter 2 Installing and Starting Up the Switch Connecting to the 10/100 Ports Follow these steps to connect to 10BaseT and 100BaseTX devices: Step 1 When connecting to workstations, servers, routers, and Cisco IP Phones, connect a straight-through Category 5 cable to an RJ-45 connector on the front panel (Figure 2-10). When connecting to switches or repeaters, use a crossover Category 5 cable. Pinouts for the cables are described in the "Crossover and Straight-Through Cable Pinouts" section on page B-4. Figure 2-10 Connecting to a 10/100 Switch Port MODE SYSTEM RPS STATUS UTIL DUPLX SPEED 12 1X 2X 34 56 78 9 10 11 12 11X 12X 22001 Note The Catalyst 3524-PWR XL switch can connect to a Cisco IP Phone through a straight-through, twisted-pair cable. The rear panel of the Cisco IP Phone might have more than one RJ-45 jack. Use the LAN-to-phone jack to connect the phone to the Catalyst 3524-PWR XL switch. Refer to the documentation that came with your Cisco IP Phone for information about connecting devices to it. 78-6456-03 Catalyst 3500 Series XL Hardware Installation Guide 2-17